Check manual page of dell_powerconnect_cpuDell PowerConnect Switches: CPU load
This check monitors the CPU load on Dell PowerConnect Switches which support the
RADWARE-MIB. It will check the percentage of the CPU load for the following states:
- 1 second (the load average of when the check ran).
- 60 seconds (the "average" over the last 60 seconds at the time the check occurred).
- 5 minutes (the "average" over the last 5 minutes, at the time the check occurred).
A single service will be created showing the percentage of CPU use at the time
the check occurred (using the 1 second load average). However, charts are created
for each of the load averages, using values obtained during each execution of the
service check.
The state of the check will return a WARNING value when the percentage of the 1 second
load value exceeds the warning threshold, and is less then the critical threshold. If the
load values exceeds the critical threshold, then it will return a CRITICAL state.
Currently, testing has been completed with the Dell PowerConnect 5448 and 5424 models,
however the service check may work with other models.
DiscoveryDuring the inventory phase of check_mk, it will identify one service CPU,
as long as the MIB defined above is supported on the switch.
|
|