Check manual page of f5_bigip_cluster_status_v11_2

Check_MK Manual

Suche im Handbuch

F5 Big-IP: active/active or passive/active cluster status

Distribution: official part of Check_MK
License: GPL
Supported Agents: SNMP

The check queries the MIB tables of F5 BIG-IP loadbalancers (local traffic managers) to identify if the cluster correctly runs in an active/active or an active/passive setup. You can configure the expected behaviour via a WATO rule. It will issue a warning if the cluster setup differs from the expected setup. This check is expected to be run on cluster hosts, since it evaluates the state of multiple nodes. If you run this check on a cluster node, it will raise no warning if the cluster node state differs from active.

Discovery

Creates on service